VersaClean™ Vanquish Floor Finish Remover

Vanquish

Floor Finish Remover

Low-odor, VOC-compliant formulation removes floor finishes fast and effectively.

Highly concentrated1:20 dilution ratio stretches chemical budget. Read
directions and cautions before use. DIRECTIONS: Preinspection: Examine the floor for evidence of pre-existing
damage. Test product in an inconspicuous a1:20 dilution ratio stretches chemical budget. For professional use only. Keep out of reach of children. Read directions and cautions before use. DIRECTIONS: Preinspection: Examine the floor for evidence of pre-existingdamage. Test product in an inconspicuous area to confirm that the ready-to-use (RTU) solution will remove the coating whilenot damaging the floor. Dilution: For removing standard acrylic finishes, mix 16 oz. (473 mL) of concentrate with water tomake 2.5 gal. (9.5 L) of RTU solution. The ready to use solution is cloudy; this is normal. Work Process: 1) Place wet floorsigns where needed. Protect areas not being cleaned. 2) Liberally apply RTU solution to the surface. Wait 10 - 20 minutesbut do not allow solution to dry on the surface. 3) Use a floor cleaning machine with a nylon brush to agitate surface. 4) Use high pressure, high temperature water to wash the surface. Remove all residues. Inspect surface to be sure that the coatinghas been removed. If necessary, repeat this process. CAUTION FOR APPLICATION: 1) Product is alkaline. Avoid contactwith surfaces that can be damaged by alkali or solvent. Examples of these surfaces are paint, wood, marble, aluminum andlinoleum. 2) If the coating begins to gel, the RTU solution is too concentrated and should be diluted further. 3) Some softstones, such as marble, do not tolerate scrubbing with a nylon brush. Do not use these brushes on such surfaces. 4) Floor becomes extremely slippery during this process.  

Vanquish SDS (8-13-2015)